Pass-Through STP Plug w/Slim Boot | HCI

The process of plug assembly can be time-consuming and difficult. The typical assembly procedure is to align the wires, trim them flush, and then insert the wires until they reach the plug’s end wall. Though it appears to be simple, the wires frequently become kinked or slack in reality. The conductivity and transmission performance might be worsened by the kink and slack.A shielded pass-through plug can be a big aid since it gives you the option of threading the wires through the end wall and then cutting them. A continuity failure rate is greatly reduced and job efficiency is greatly improved. Works with 007A8ST014 Series Crimping Tool. Termination and cutting of wires simultaneously.The 8-position groove inside the plug housing is 1.0mm+0.02/-0mm wide and the entrance accepts cable sizes smaller than 5.5mm. The 3-prong blades enhance the certainty of piercing both the solid and the stranded cable so excellent conductivity can be assured.Exceeds TIA-568.2-D and ISO/IEC 11801 Cat 5e transmission standards. The entry-level connector for 100MHz Gigabit Ethernet. Explore HCI categories to plan complete Pass-Through STP Plug w/Slim Boot cabling solutions. Move from families to matched components for stable channels.