Snagless Pass-Thru C6 Plugs w/Boot | HCI

Snagless Pass-Through Plug has two main distinctive features.“The Snagless” prevents lots of cable snags when managing daily network distribution: move, add and change (MAC). It allows easy pulling through crowded distribution frames or cable management trays.“The Pass-Through” enables the threading of all wires through the plug's end wall for subsequent cutting. It lowers continuity-failure rates and significantly boosts task efficiency.A typical Cat 6 UTP cable has an insulation diameter ranging from 0.9mm to 1.0mm with nominal cable O.D. from 5.9mm(riser) to 6.5mm(plenum).The 8-position groove inside the plug housing has a diameter of 1.05mm and 1.15mm for options. Additionally, the cable entrance is 6.5mm wide and can accommodate patch cables as well as horizontal cables. The 3-prong blades enhance the certainty of piercing both the solid and the stranded cables so excellent conductivity can be assured.It must work with 007A8ST025 Series Crimping Tool. The tool performs wire termination and cutting at the same time.Exceeds TIA-568.2-D and ISO/IEC 11801 Cat 6 transmission standards. The refined connector for running at 250MHz Gigabit Ethernet. Explore HCI categories to plan complete Snagless Pass-Thru C6 Plugs w/Boot cabling solutions. Move from families to matched components for stable channels.